300-515

Practice 300-515 Exam

Is it difficult for you to decide to purchase Cisco 300-515 exam dumps questions? CertQueen provides FREE online Implementing Cisco Service Provider VPN Services (SVPI) 300-515 exam questions below, and you can test your 300-515 skills first, and then decide whether to buy the full version or not. We promise you get the following advantages after purchasing our 300-515 exam dumps questions.
1.Free update in ONE year from the date of your purchase.
2.Full payment fee refund if you fail 300-515 exam with the dumps

Full 300-515 Exam Dump Here

Latest 300-515 Exam Dumps Questions

The dumps for 300-515 exam was last updated on May 05,2025 .

Viewing page 1 out of 3 pages.

Viewing questions 1 out of 15 questions

Question#1

While implementing Layer 3 MPLS VPN, which feature should an engineer use at the PEs to transform the customer IPv4 prefixes into a unique 96-bit prefix

A. RT

B. VC ID

C. RD

D. PW ID

Question#2

Refer to the exhibit.

Which statement about this command is true?

A. It must be configured on each PE router to enable the PE routers to receive multicast traffic for this particular MVR

B. It is used to set the designated router on a link using PIM-S

C. It must be configured on the PE and CE router to enable MP-BGP to send labels for CS

D. It is used to set the router that will server as the root bridge for ST

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr1000/configuration/guide/chassis/asrswcfg/lsmmldp.html

Question#3

Which effect of this configuration is true?

A. It configures VPWS multihomed.

B. It configures VPWS single homed.

C. It configures an IPv4 peering with 192.168.1.1

D. It configures MPLS traffic engineering.

Explanation:
Reference: https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2019/pdf/BRKSPG-2798.pdf

Question#4

Which kind of traffic is supported in an MVPN Extranet?

A. PIM dense mode with Reverse Path Forwarding

B. PIM dense mode

C. PIM sparse mode

D. Bidirectional PIM

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_mvpn/configuration/xe-16/imc-mvpn-xe- 16-book/imc-mc-vpn-extranet.html

Question#5

While configuring the VRF Selection feature, you get an error message after typing the below statement:
Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1
Which action caused this message?

A. the entry of an inconsistent IP address and mask for VRF Selection

B. an attempt to configure a VRF instance on an interface that already has VRF Selection configured

C. an attempt to remove a VRF Selection entry that does not exist

D. an attempt to configure a VRF Selection table that does not exist

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios/12_2/12_2sz/feature/guide/122szvrf.html

Exam Code: 300-515 Q & A: 71 Q&As Updated: May 05,2025

Full 300-515 Exam Dumps Here

Exam Code: 300-515
Q & A: 71 Q&As
Updated: May 05,2025

About 300-515 Dumps