FCSS_NST_SE-7.6

Practice FCSS_NST_SE-7.6 Exam

Is it difficult for you to decide to purchase Fortinet FCSS_NST_SE-7.6 exam dumps questions? CertQueen provides FREE online Fortinet NSE 6 - Network Security 7.6 Support Engineer FCSS_NST_SE-7.6 exam questions below, and you can test your FCSS_NST_SE-7.6 skills first, and then decide whether to buy the full version or not. We promise you get the following advantages after purchasing our FCSS_NST_SE-7.6 exam dumps questions.
1.Free update in ONE year from the date of your purchase.
2.Full payment fee refund if you fail FCSS_NST_SE-7.6 exam with the dumps

Full FCSS_NST_SE-7.6 Exam Dump Here

Latest FCSS_NST_SE-7.6 Exam Dumps Questions

The dumps for FCSS_NST_SE-7.6 exam was last updated on Dec 29,2025 .

Viewing page 1 out of 2 pages.

Viewing questions 1 out of 14 questions

Question#1

In the SAML negotiation process, which section does the Identity Provider (IdP) provide the SAML attributes utilized in the authentication process to the Service Provider (SP)?

A. SP Login dump

B. Authentication Response

C. Authentication Request

D. Assertion dump

Question#2

Exhibit.

Refer to the exhibit, which shows the output of a session.
Which two statements are true? (Choose Iwo.)

A. The TCP session has been successfully established.

B. The session was initiated from an authenticated user.

C. The session is being inspected using flow inspection.

D. The session is being offloaded.

Question#3

Exhibit.

Refer to the exhibit, which contains partial output from an IKE real-time debug.
Which two statements about this debug output are correct? (Choose two.)

A. Perfect Forward Secrecy (PFS) is enabled in the configuration.

B. The local gateway IP address is 10.0.0.1.

C. It shows a phase 2 negotiation.

D. The initiator provided remote as its IPsec peer I

Question#4

An administrator wants to capture encrypted phase 2 traffic between two FotiGate devices using the built-in sniffer.
If the administrator knows that there Is no NAT device located between both FortiGate devices, which command should the administrator run?

A. diagnose sniffer packet any 'udp port 500'

B. diagnose sniffer packet any 'lp proto 50'

C. diagnose sniffer packet any 'udp port 4500'

D. diagnose sniffer packet any 'ah'

Question#5

Which statement about protocol options is true?

A. Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.

B. Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.

C. Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.

D. Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.

Exam Code: FCSS_NST_SE-7.6 Q & A: 95 Q&As Updated: Dec 29,2025

Full FCSS_NST_SE-7.6 Exam Dumps Here

Exam Code: FCSS_NST_SE-7.6
Q & A: 95 Q&As
Updated: Dec 29,2025

About FCSS_NST_SE-7.6 Dumps