FCSS_SDW_AR-7.4

Practice FCSS_SDW_AR-7.4 Exam

Is it difficult for you to decide to purchase Fortinet FCSS_SDW_AR-7.4 exam dumps questions? CertQueen provides FREE online FCSS - SD-WAN 7.4 Architect FCSS_SDW_AR-7.4 exam questions below, and you can test your FCSS_SDW_AR-7.4 skills first, and then decide whether to buy the full version or not. We promise you get the following advantages after purchasing our FCSS_SDW_AR-7.4 exam dumps questions.
1.Free update in ONE year from the date of your purchase.
2.Full payment fee refund if you fail FCSS_SDW_AR-7.4 exam with the dumps

 

 Full FCSS_SDW_AR-7.4 Exam Dump Here

Latest FCSS_SDW_AR-7.4 Exam Dumps Questions

The dumps for FCSS_SDW_AR-7.4 exam was last updated on Jun 03,2025 .

Viewing page 1 out of 4 pages.

Viewing questions 1 out of 20 questions

Question#1

Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

A. Interface-based shaping mode
B. Reverse-policy shaping mode
C. Shared-policy shaping mode
D. Per-IP shaping mode

Explanation:
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.

Question#2

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)


A. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
B. The measured bandwidth is less than 100 KBps.
C. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
D. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.

Question#3

Refer to the exhibits.
Exhibit A



Exhibit B



Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt.
Exhibit B shows the system global and system settings configuration on dc1_fgt.
When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferred member in the matching SD-WAN rule.
Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?

A. Enable auxiliary-session under config system settings.
B. Disable tсp-session-without-syn under config system settings.
C. Enable snat-route-change under config system global.
D. Disable allow-subnet-overlap under config system settings.

Question#4

Refer to the exhibit.



Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)

A. FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.
B. FortiGate performs routing lookups for new sessions only, after a route change.
C. FortiGate always blocks all traffic, after a route change.
D. FortiGate flushes all routing information from the session table, after a route change.

Question#5

Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?

A. hold-down-time
B. link-down-failover
C. auto-discovery-shortcuts
D. idle-timeout

Exam Code: FCSS_SDW_AR-7.4         Q & A: 99 Q&As         Updated:  Jun 03,2025

 

 Full FCSS_SDW_AR-7.4 Exam Dumps Here